USE CODE 'LABORDAY15' AT CHECKOUT 🚚 SHIPS WITHIN 2 DAYS.*
Small but mighty, this little drilling jig will save you time! This incredibly easy to use jig makes pre-drilling holes for rubber/plastic cutting board feet a breeze. Forget wasting time measuring each corner offset with a tape or ruler to get your positioning just right, our 'Corner Feet Drilling Jig' features a series of diagonally offset holes at 0.5", 0.75", 1.0", 1.5", 2.0", 2.5" and 3.0" to make drilling for cutting board feet a dream. Use the hole pattern with a pen or pencil to mark the holes on your board or simply drill through the holes in the jig directly with your drill bit.
The 7/64" holes in the jig are ideal for a 7/64" drill bit or less. If you use thicker screws with your cutting board feet feel free to use a 1/8" drill bit to initially drill out the holes in the jig to a slightly larger diameter. The larger hole at the corner opposite the alignment tabs is big enough to allow it to hang on most tool board hooks, because we all know how small gadgets like to get lost around the shop!
This jig will also work with cutting boards and serving boards that have a corner radius of up to 2".
While this jig isn't saving anyone hours, it will save you boring and monotonous minutes of time from marking or drilling holes for raised feet. Dare we say that this jig makes attaching cutting board feet great again? :-P
Note: While the jig is shown in black in the photos, the color you will receive is dependent on the materials currently available in our production facility. As a general rule you can expect black, gray or blue.
Customer Reviews
Overall rating: 4.8 / 5 from 235 reviews.
Perfect not only to use for corner feet but to line magnets.
So simple but saved so much time
Takes the guess work out of measuring left and right top and bottom.
Place in the corner. Select your placement, Pilot hole … done!
I know it’s not a standard use, but the smaller holes work on round pieces also. Depending on the radius of your piece, the smaller holes can still be used for exact placement. I think the 4 smaller holes were usable here. It would work well for feet placement also. It makes an easy to mess up project easy to complete. When I make a project and am in the last few processes, I will use anything to help make it easier.
Step 1: Choose message placement
Click the button below and then hover over your page to select a placement.
Step 2: Paste and save
You have copied the placement for the Product Page.
Go back to the App Embeds section, and in the Paypal Advanced Settings, paste the copied value into the
Product Page field and click the 'Save' button in the top right corner.
