A special seasonal release just in time to celebrate Christmas. Only Available until early December. We have all seen the "Santa Snack" trays and boards on Etsy, at craft and Christmas shows, but until now they have usually been one color laser, CNC engraved or vinyl cut designs on wood.... that's boring. We are proud to introduce the first Santa Snacks Tray silicone mold. This mold allows for incredible artistic flexibility. You can do a multi-step pour, coloring each of the embossed elements separately with tinted resin. You can embed objects (like peppermint candy canes!) into the body, or you can keep it simple and cast solid color boards then backfill in the embossed sections with acrylic paint.
The finished casting out of this mold is 16x12" and up to 7/8" (0.875") thick when filling the mold to the top. You can fill the mold as little as 3/8" thick if you wish to save material and create a thinner board. The integrated handles on each side are 3" high by 3/4" wide.
This is specifically an 'art' mold due to the thickness, engraved design, profile and characteristics of the mold. It is designed to be used with epoxy resin, urethane resin, concrete or plaster only. Like all of our silicone molds a mold release spray is highly recommended before casting resin in this mold to prolong its life and avoid mold tear-out.
Crafted Elements Silicone Molds
The last mold you will ever need. Created just for makers, resin artists and wood workers, these time saving flexible yet durable silicone molds significantly cut down on the setup and demolding time usually involved with other molds. Silicone molds are superior to wood and tuck tape, and HDPE molds because:
They can be used with epoxy resin, resin and wood, concrete, Jesmonite, plaster and more.
They never need assembled, or disassembled. Saving huge amounts of time.
The strength and flexibility of the molds allows you to insert and remove pieces of wood easily.
The corners and edges never need sealed.
When using wood, the wood stays in place, tight in the mold if you cut it 1/16" larger than the width of the mold. Preventing the need for clamps or weights.
The mold is heat resistant to ~450F. Avoid direct contact with the flame of a torch. Briskly wave your torch or use a heat gun to pop bubbles.
The molds are reusable. However silicone molds do have a finite lifespan when used with epoxy resin, but getting 20-30+ castings out of the mold can be expected when they are properly cared for and a mold release spray is used.
Like HDPE, epoxy resin does not stick to silicone. However, the heat generated by the exothermic reaction and the chemicals in epoxy resin are very harsh to all silicone molds. Additionally, if part of your epoxy has not fully set due to improper mixing, the epoxy can become bonded to the mold. Both of these factors can lead to mold tear out when removing your piece from the mold, leading to pits and tears on the surface of the mold. This is why we strongly recommend the use of non-silicone based mold release spray before each pour to increase the life of your mold. We use the 'MG Chemicals 8329 Non-Silicone Epoxy Mold Release', Smooth-On Ease Release 200 or Mann Ease Release 200 which are readily available from Amazon and other online retailers. Cooking spray, vaseline, silicone based sprays or sprays designed for urethane or polyester products should NEVER be used. Using a proper, non-silicone based mold release can mean the difference between getting only a couple of uses from your mold to 20, 30 or more.