Your cart
Close Alternative Icon
WE SHIP WORLDWIDE - FREE SHIPPING FOR ORDERS $100+ WITHIN THE USA & CANADA* WE SHIP WORLDWIDE - FREE SHIPPING FOR ORDERS $100+ WITHIN THE USA & CANADA*
25x5x1.5" Silicone Mold For Epoxy Resin - Long Board & Coaster Form
25x5x1.5" Silicone Mold For Epoxy Resin - Long Board & Coaster Form
25x5x1.5" Silicone Mold For Epoxy Resin - Long Board & Coaster Form
25x5x1.5" Silicone Mold For Epoxy Resin - Long Board & Coaster Form
25x5x1.5" Silicone Mold For Epoxy Resin - Long Board & Coaster Form

25x5x1.5" Silicone Mold For Epoxy Resin - Long Board & Coaster Form

SKU CE-MOLD-SIL-25X5X1.5

$165.00
FREE SHIPPING


Restock Expected February
Interior Size: 25x5x1.5"
Fluid Volume:
104oz / 3080ml
Wall Thickness: 5/8"
Material: Silicone Rubber - Shore 40A
Interior Finish: Matte

The 25x5x1.5" mold was designed for two purposes. First, as a mold used to create long and skinny boards for use as cheese or bread boards. Second, to be a coaster set mold, allowing the creation of (5) 5x5" coasters (or 4.5x4.5" or 4x4" coasters if you trim the long edges before slicing into coasters). We opted for the 5" width to allow it to be used for long cheeseboards, but also to allow for a margin of error when used as a wood and epoxy mold for coasters. Wood and epoxy pours often require trimming of the sides anyway, so making a mold only 4" wide would result in smaller than standard coasters after trimming.

The last mold you will ever need. Created just for makers, resin artists and wood workers, these time saving flexible yet durable silicone molds significantly cut down on the setup and demolding time usually involved with other molds. Silicone molds are superior to wood and tuck tape, and HDPE molds because:

  • They can be used with epoxy resin, resin and wood, concrete, plaster and more.
  • They never need assembled, or disassembled. Saving huge amounts of time.
  • The strength and flexibility of the molds allows you to insert and remove pieces of wood easily.
  • The corners and edges never need sealed.
  • When using wood, the wood stays in place, tight in the mold if you cut it 1/16" larger than the width of the mold. Preventing the need for clamps or weights.
  • The mold is heat resistant (within reason!), and wont damage when you are popping epoxy bubbles with a torch or heat gun.
  • The molds are reusable. However silicone molds do have a finite lifespan when used with epoxy resin, but getting 20-30+ castings out of the mold can be expected when they are properly cared for and a mold release spray is used.
  • Like HDPE, epoxy does not stick to silicone. However in rare cases where the epoxy hasn't fully set (and is still mildly tacky) it can be harder to remove, and potentially create pits or small tears inside the mold when your piece is pulled out. Thus, we recommend the use of mold release spray before each pour to increase the life of your mold. We use the 'MG Chemicals 8329 Non-Silicone Epoxy Mold Release', or Smooth On Ease Release™ 200 which is readily available on Amazon.
  • Mold Instructions & Care - Click Here